Switch between metal powders without replacing the filter, so your machine spends more time printing and less time being prepared

Changing alloy on a powder bed machine is more than swapping powder. The previous material has to be removed from the build chamber, the feed, and the overflow. Surfaces and the recoater have to be cleaned. And the filtration system, which has been collecting residue from the previous material, has to be dealt with.
On most machines, the filter is the slowest and messiest part of that job. The element is loaded with powder, so it is removed and replaced, partly to avoid carrying residue from one alloy into the next.
With the Permanent Filtration System, the main filter element is no longer replaced at a material change.
A baffle stops powder from reaching the element, so it only collects fume condensate. At changeover, the operator runs Reverse Blow from the machine’s control software. The airflow reverses, the collected residue drops into the tank below, and the element is ready for the next material. There is no disassembly and no new element to fit.
|
At a material change |
Conventional filter |
Permanent filtration system |
|
Main filter element |
Removed and replaced |
Cleared in place with Reverse Blow |
|
Residue from previous alloy |
Leaves with the old element |
Emptied into the tank before the next material |
|
Filter consumable |
New element each time |
None for the main element |
|
Operator task |
Filter replacement |
Run Reverse Blow, empty the tank |
More printing hours. Every hour saved on a changeover is an hour the machine can print. The more often you switch materials, the more this adds up.
Mixed-material work becomes practical. A job in 316L followed by a job in AlSi10Mg no longer means a long stop for filter work. That makes small batches in different alloys easier to schedule.
Lower cost per change. No filter element to buy for each material switch.
Cleaner switches. The filter is cleared before the new material goes in, which reduces the risk of carrying residue from one alloy into the next.
Faster development work. Research teams testing several powders, often with the Build Volume Reducer, can move between materials without a filter swap each time.
Service bureaus handle unpredictable demand across many materials. As our HLH Prototypes case describes, material changes are one of the events that interrupt output. Shorter changeovers keep each machine available for more of the job mix.
The same applies to manufacturers running parts in more than one alloy, and to labs working through material tests.
The ANiMA A1 and iSLM160 add a fourth filter stage for reactive powders such as titanium and aluminium alloys. Before that filter is removed, the collected material can be wetted with oil so it can be handled safely. Site-level safety still depends on installation, extraction, waste handling and national rules, so confirm requirements with your safety authority.
Does a material change require a filter replacement?
How long does a full changeover take, from the last build in one material to the first build in the next?
How is cross-contamination between alloys prevented?
Which consumables does each changeover use?
How are reactive powder residues handled safely?
Fast material changeover takes the filter out of the material switch. The element is cleared from the control software instead of replaced, so changeovers are shorter, cleaner and cheaper. For anyone running more than one alloy, that means more machine hours spent printing.
Recommended next steps:
Tell us which materials you run and how often you switch between them.
Ask for the full changeover procedure and the time it takes on your preferred machine.
Read how the Permanent Filtration System works.
Related advantages: Permanent Filtration System · Print-Time Estimation · Build Volume Reducer · Fully Open Parameters · Wide Material Support